Mitsubishi ECLIPSE CROSS 2017 Owner's Manual page 237

Accelerate to driver's desired vehicle speed
and push down SET - switch (B) and release.
Control state "LIMIT" is displayed again and
the set speed is updated.
To decrease the set speed
By using the SET - switch
Push down the "SET -" switch (B).
Then the set speed displayed in the combina-
tion meter is gradually decreased.
If the set speed reaches to your desired speed,
release the "SET -" switch (B).
The set speed decreases approximately
5 km/h (3 mph) per approximately 0.5 sec-
ond.
If a driver wants to decrease the set speed a
little, press the "SET -" switch (B) for less
E00634000017
than approximately 0.5 second and release it.
The set speed is decreased 1 km/h (1 mph)
each taps.
E00634101116
By using the CANCEL switch,
the service brake and the SET -
switch
Press the "CANCEL" switch (D) to deacti-
vate the Speed Limiter.
Control state "LIMIT" is disappeared and
change control state "LIMIT OFF" in the
combination meter.
Control state "LIMIT" is disappeared and
change control state "LIMIT OFF" in the
combination meter.
E00634201117
OGKE18E1
Speed Limiter*
Starting and driving 6-63
6