Mitsubishi ECLIPSE CROSS 2017 Owner's Manual page 161

NOTE
l If the sensor or its surrounding area reaches
an extremely high temperature when parking
the vehicle under a blazing sun, the "AHB
SERVICE REQUIRED" warning display
may appear.
If the warning display remains even after the
temperature of the sensor or its surrounding
area has been in range, please contact a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
Sensor is too hot or cold
If the system becomes temporarily unavaila-
ble due to a high or low temperature of the
sensor, the following warning display will
appear.
After the temperature of the sensor has been
in range, the system will automatically return
to operation.
If the warning display does not disappear af-
ter waiting for a while, there is a possibility
that the automatic high-beam system has a
malfunction. Contact a MITSUBISHI
MOTORS Authorized Service Point for in-
spection of the system.
Windscreen is dirty
If the AHB determines that its performance
has been degraded, the warning display will
appear.
This can occur when:
l Foreign objects, such as dirt, snow or
ice, adhere to the windscreen of the sen-
sor portion.
l In adverse weather conditions, such as
rain, snow, sandstorms, etc.
l A vehicle in front or an oncoming vehi-
cle is splashing water, snow or dirt.
When the sensor performance returns, the
AHB will resume operation.
If the warning display does not disappear af-
ter waiting for a while, there is a possibility
that the sensor has a malfunction. Contact a
MITSUBISHI MOTORS Authorized Service
Point for inspection of the sensor.
OGKE18E1
Combination headlamps and dipper switch
Welcome light
This function turns on the position and tail
lamps for approximately 30 seconds after the
UNLOCK switch on the key is pressed when
the combination headlamps and dipper switch
is in the "AUTO" position. The welcome
light function will operate only when it is
dark outside the vehicle.
NOTE
l While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Press the LOCK switch on the key.
• Turn the combination headlamps and dip-
per switch to the " " or "
• Turn the ignition switch to the "ON" posi-
tion or put the operation mode in ON.
l It is possible to modify functions as follows:
• The headlamps can be set to come on in
the low beam setting.
• The welcome light function can be deacti-
vated.
For further information, please contact your
MITSUBISHI MOTORS Authorized Serv-
ice Point.
On vehicles equipped with the Smartphone
Link Display Audio or the MITSUBISHI
Multi-Communication System
screen operations can be used to make the
adjustment. Refer to the separate owner's
manual for details.
Instruments and controls
E00528902157
5
" position.
(MMCS),
5-61