Multi-information display
Changing the language cooper-
ative control
The language used in MITSUBISHI Multi-
Communication System (MMCS) (if so
®
equipped), the Bluetooth
equipped) or Multi Around Monitor (if so
5
equipped) can be changed automatically to
the same language as that shown in the multi-
information display.
1. Switch to the function setting screen.
Refer to "Changing the function set-
tings" on page 5-13.
2. Press the
switch or
times to switch to the "LANGUAGE
SYNC" screen. Then, press the
to switch to the setting selection screen.
5-18
Instruments and controls
3. Press the
the setting, and then press the
to confirm the setting.
E00523301768
The setting is changed to the selected
condition.
2.0 interface (if so
NOTE
l
The language display modified with the lan-
guage setting can be switched in the follow-
ing manner.
•
When "ON" (language cooperation ena-
bled) has been selected with the language
cooperative control, the language for
MITSUBISHI Multi-Communication Sys-
switch several
tem (MMCS) (if so equipped), the Blue-
tooth
switch
Multi Around Monitor (if so equipped) is
automatically changed to the language se-
lected for the multi-information display.
However, this changing function may not
work depending on the language selected
for the multi-information display.
•
When "OFF" (language cooperation disa-
bled) has been selected with the language
cooperative control, the language for
MITSUBISHI Multi-Communication Sys-
tem (MMCS) (if so equipped), the Blue-
tooth
Multi Around Monitor (if so equipped) is
not automatically changed to the language
selected for the multi-information display.
switch or
switch to select
switch
®
2.0 interface (if so equipped) or
®
2.0 interface (if so equipped) or
OGKE18E1
NOTE
l
The language on the display of the audio
system (if so equipped) is not automatically
changed even if you select "ON" (language
cooperation enabled) of the language coop-
eration control.
Operation sound setting
You can change the operation sounds of the
multi-information display switches and rheo-
stat illumination button.
1. Switch to the function setting screen.
Refer to "Changing the function set-
tings" on page 5-13.
2. Press the
switch or
switch several
times to switch to the "OPERATION
SOUND" screen. Then, press the
switch to switch to the setting selection
screen.
E00523401815