Mitsubishi ECLIPSE CROSS 2017 Owner's Manual page 238

Speed Limiter*
Decelerate to driver's desired speed and push
down SET - switch (B) and release.
6
The Speed Limiter indication is displayed
again and the set speed is updated.
To increase the vehicle speed
temporarily
A driver can temporarily accelerate for emer-
gency use.
The Speed Limiter is temporarily deactiva-
ted, and the vehicle speed can be increased.
6-64 Starting and driving
The Speed Limiter will resume when the ve-
hicle speed goes down to enough less than
the set speed.
Put on an accelerator pedal to the pedal
stroke end. (over a detent that makes pedal
reaction force bigger before pedal stroke end)
CAUTION
E00634301105
l
There is a possibility for the Speed Limiter
to allow abrupt acceleration corresponding
to accelerator pedal position. So be careful
of the abrupt acceleration.
If the vehicle speed exceeds the set speed by
approximately +3 km/h (2 mph), alert mes-
sages appear in the combination meter.
OGKE18E1
CAUTION
l
Be careful about over speed.
NOTE
l A driver can change the set speed during this
emergency use.
To deactivate
Use whichever following ways to deactivate.
l
Press CANCEL switch
l Press the Speed Limiter ON/OFF switch
l If CRUISE CONTROL ON/OFF switch
or ACC ON/OFF switch is pressed, the
Speed Limiter will be cancelled.
NOTE
l If the Speed Limiter is cancelled by other
states, it may be a system malfunction.
Stop using the Speed Limiter and turn off
the Speed Limiter. Have your vehicle in-
spected by a MITSUBISHI MOTORS Serv-
ice Point.
E00634400011