Mitsubishi ECLIPSE CROSS 2017 Owner's Manual page 411

NOTE
l
On vehicles with a T155/90D16
T155/80D17 size spare wheel, the clamp
cannot be used for a normal size tyre.
l When storing a normal size flat tyre in the
space for the spare wheel under the luggage
floor board, the luggage floor board will be
positioned higher than usual.
3. Have your damaged tyre repaired as
soon as possible.
To store the tools and jack
Reverse the removing procedure when stor-
ing the jack, jack bar and wheel nut wrench.
Refer to "Tools and jack*" on page 8-05.
Wheel covers*
or
To remove
Wrap the tip of the jack bar with a cloth, in-
sert it into the notch provided in the wheel
cover, and pry the cover away from the
wheel. Using the same procedure at the other
wheel cover notches, work the wheel cover
away from the wheel to remove it complete-
ly.
E00803800037
CAUTION
l
Removing the cover with your hands may
cause injury to the fingers.
NOTE
l The wheel cover is made of plastic. Pry it
loose carefully.
To install
1. Make sure the tabs (A) of the back of the
E00801301846
2. Align the air valve (C) of the tyre with
OGKE18E1
How to change a tyre
wheel cover are not broken and correctly
fitted on the rings (B). If in doubt, do not
install the wheel cover and consult your
MITSUBISHI MOTORS Authorized
Service Point.
the notch (D) in the wheel cover.
For emergencies
8
8-19