Mitsubishi ECLIPSE CROSS 2017 Owner's Manual page 75

For the rear passenger's seats
If the ignition switch is turned to the "ON"
position or the operation mode is put in ON
while a seat belt is not fastened, the warning
lamp comes on for approximately 30 seconds
to remind the rear passenger to fasten the seat
belt.
If the vehicle is driven with the seat belt still
unfastened, the warning lamps come on for
approximately another 30 seconds. (This illu-
mination happens only the first time the vehi-
cle starts moving with the seat belt still un-
fastened.)
The warning lamps go off when the seat belt
is fastened.
WARNING
E00415501076
l
Do not install any accessory or sticker
that makes the lamp difficult to see.
NOTE
l The warning lamp comes on even if no one
is sitting on the rear seats.
l If a seat belt is unfastened while the vehicle
is being driven, the tone sounds for approxi-
mately 1 second and the warning lamp
comes on for approximately 30 seconds. At
the same time, the warning lamp for the seat
where the seat belt is not fastened comes on.
l
If the seat belts are initially fastened but a
seat belt is unfastened while the vehicle is
stationary and the vehicle is then driven with
the seat belt still unfastened, the warning
lamp for the seat where the seat belt is not
fastened comes on again for approximately
30 seconds.
Adjustable seat belt anchor
(front seats)
The seat belt anchor height can be adjusted.
Raise or lower the seat belt anchor (A) while
pulling the lock knob (B).
l
OGKE18E1
Seat belts
WARNING
When adjusting the seat belt anchor, set it
at a position that is sufficiently high so
that the belt will make full contact with
your shoulder but will not touch your
neck.
Seats and seat belts
E00405001746
4
4-11