Table 13. Memory specifications
Memory module
Memory capacity
sockets
Twenty-four 288-
•
64 GB quad rank (LRDIMMs)
pins
•
16 GB or 32 GB dual rank
(RDIMMs)
Hard drive specifications
™
The VxRail
E Series appliance supports up to ten 2.5-inch, internal, hot-swappable SAS, or Nearline SAS hard drives.
Ports and connectors specifications
USB ports
The VxRail
™
E Series appliance supports:
•
One micro USB 2.0-compliant port on the front panel
•
Two 9-pin USB 3.0 - complaint ports on the back panel
NIC ports
™
The VxRail
E Series appliance supports four Network Interface Controller (NIC) ports on the back panel, which is available in one of the
following NIC configurations:
•
Two 10/100/1000 Mbps RJ45 connectors and two 100 Mbps/1 Gbps/10 Gbps SFP+ or RJ45 connectors
•
An optional PCIe NIC, which has either two 100Mbps/1Gbps/10Gbps SFP+ or RJ45 connectors
Serial connector
The serial connector connects a serial device to the appliance. The VxRail
panel, which is a 9-pin connector, Data Terminal Equipment (DTE), 16550-compliant.
Internal dual SD Module
The Internal Dual SD module (IDSDM) provides you with a redundant SD card solution. The IDSDM card offers the following feature:
•
Dual card operation — Maintains a mirrored configuration by using SD cards in both the slots and provides redundancy.
NOTE:
The IDSDM on the VxRail appliance is pre-configured for appliance bare metal recovery. Do not change any of the
settings.
Minimum RAM
•
64 GB with single processor
(minimum of four memory
modules)
•
128 GB with dual processors
(minimum four memory modules
per processor)
™
E Series appliance supports one serial connector on the back
Maximum RAM
•
LRDIMM: up to 768 GB with
single processor
•
LRDIMM: up to 1536 GB with dual
processors
•
RDIMM: up to 384 GB with single
processor
•
RDIMM: up to 768 GB with dual
processors
Technical specifications
19