Bomag BW 219 DH-4 Service Training page 1054

18.5
INSTALLATION AND ADJUSTMENT OF BEVEL PINION - INSTALLAZIONE E REGISTRAZIONE PIGNONE CONICO - INSTALLATION UND
EINSTELLUNG DES KEGELRADS - INSTALACION Y AJUSTE DEL PIN Ä ON CONICO - INSTALLATION ET REGLAGE DU PIGNON CONIQUE
16
GB
With the help of the press, install the internal, countermarked
bearing (17) onto the pinion (16).
CAUTION! Lubricate pinion with oil.
23
GB
Fit the reduction gear (11) into the main body (23) without
differential unit; lock temporarily with the two lower screws (9).
Fit the bearing (15) of the motion in gear and lock it.
12
GB
Between the body of the reduction gear (11) and the gear (12) of the
pinion, place block "A" used for disassembling, and tighten the nut
(13) to a minimum required tightening torque of 500 Nm, using a
box wrench and a dynamometric wrench.
1054
17
F1241213
a
11
15
9
F1241215
c
11
A
F1241217
e
16
Fit the pinion (16), the shims (19), the distance piece (20) and the
external bearing (21) into the body of the reduction gear (11) and
assemble the unit with a press.
CAUTION! Lubricate pinion with oil.
Fit the gear (12) of the pinion; coat the nut (13) with Loctite 242 and
hand-screw it.
78 BOMAG
Essieu
11
F1241214
b
GB
12
13
F1241216
d
GB
f
GB
008 924 62