18.5
ASSEMBLY OF PLANETARY REDUCTION AND AXLE SHAFT - ASSEMBLAGGIO RIDUTTORE EPICICLOIDALE E SEMIASSE - PLANETENGE-
TRIEBE UND HALBACHSE ZUSAMMENBAUEN - MONTAJE REDUCTOR EPICICLOIDAL Y SEMIEJES - ASSEMBLAGE DU REDUCTEUR
6
GB
Coat the screws (6) with Loctite 270 and screw them.
Tighten screws (6) in two stages, using the criss-cross method.
Initial torque wrench setting: 120 Nm
Final torque wrench setting: 219 ± 242 Nm
3
2
GB
Fit the planetary gear cover (2) onto the wheel hub (3).
CAUTION! 1 - Check the condition and position of the O-ring (16).
2 - Line up the locating release points.
GB
1018
EPICICLOIDALE ET DU DEMI-ESSIEU
F1241130
a
16
F1241131
c
e
42
BOMAG
11
4
GB
Lubricate the snap ring (11), the toothed portions and the sealing
surface of the axle shaft.
Install the axle shaft (4), making sure that it is properly inserted into
braking disks and differential unit.
1
2
GB
Lock the planetary gear cover (2) onto the wheel hub (3) with
screws (1).
Screws torque wrench setting: 40 ± 0 Nm.
GB
Essieu
F1241107
b
F1241132
d
f
008 924 62