Bomag BW 219 DH-4 Service Training page 1038

18.5
REMOVAL AND DISASSEMBLY OF THE DIFFERENTIAL UNIT - ASSEMBLAGGIO ED INSTALLAZIONE GRUPPO DIFFERENZIALE -
DIFFERENTIALAGGREGAT ZUSAMMENBAUEN UND INSTALLIEREN - MONTAJE E INSTALACION DEL GRUPO DIFERENCIAL -
1
32
34
33
GB
Remove the screws (33) and remove the safety tabs (34).
35
GB
Remove the spring ring (35) and extract the cap (36) to allow
checking of the clearance between pinion and crown to take place.
38
GB
Coat screws (38) with Loctite 242 and screw tight. Tighten screws
(38), using the criss-cross method and a tightening torque of
129 ± 143 Nm.
1038
ASSEMBLAGE ET INSTALLATION DU GROUPE DIFFERENTIEL
F1241182
a
36
F1241184
c
F1241186
e
Using wrench T9, extract the adjustment ring nuts (32) and remove
any residue of thread locking substances.
Screw ring nuts again after applying Loctite 242.
37
Coat the surface of the main body (3) with Loctite 510 and install
the reduction gear (37) complete with pinion.
NOTE. Make sure that a continuous layer of sealant runs around
the locking holes.
Screw ring nut (32) on crown wheel side until clearance between
pinion and crown equals zero, then unscrew by 1/4 turn approx.
62 BOMAG
Essieu
32
T9
F1241183
b
GB
3
F1241185
d
GB
32
T9
F1241183
f
GB
008 924 62