Bomag BW 219 DH-4 Service Training page 1042

18.5
REMOVAL AND DISASSEMBLY OF THE DIFFERENTIAL UNIT - ASSEMBLAGGIO ED INSTALLAZIONE GRUPPO DIFFERENZIALE -
DIFFERENTIALAGGREGAT ZUSAMMENBAUEN UND INSTALLIEREN - MONTAJE E INSTALACION DEL GRUPO DIFERENCIAL -
36
GB
Using a driver and a plastic hammer, install the driving gear (39).
41
42 43
GB
Lock the cover (40), using the snap washers (43) and the screws
(42) and (41) adequately tightened to a torque of 82 ± 91 Nm.
Tighten screws (42) and (41) with a tightening torque of 82 ± 91 Nm.
GB
Complete assembly of the axle by installing, in the following order,
brake cylinders and complete arms.
For details, see «ASSEMBLING THE BRAKING UNITS».
1042
ASSEMBLAGE ET INSTALLATION DU GROUPE DIFFERENTIEL
F1241190
a
Apply Loctite 510 to the surface of the reduction gear body (37) and
install the cover (40).
NOTE. Make sure that a continuous layer of sealant runs around
the locking holes.
40
F1241193
c
Install the breath union piece (44) with the relative sealing washers
(45) and plugs (47) and (46); tighten to a torque of 35 ± 50 Nm.
e
66 BOMAG
37
40
GB
46
47
GB
GB
Essieu
F1241192
b
44
F1241194
d
f
008 924 62