Transmitting Files Through The Net Port - EDAN SE-601 Series User Manual

SE-601 Series Electrocardiograph User Manual
1) When the main interface1 is displayed, press the function key F5 below to open
the main interface2.
2) Press the function key F1 below Setup to open the System Setup interface.
3) Press F1, F2, F3, F4, Tab or Shift + Tab to move the cursor. When the cursor is on
Transmission, press Enter to open the Transmission Setup interface.
4) For SE-601B/C, press F1 or F2 to select UART. For SE-601A, press F3 or F4 to select
UART.
5) Press Enter to confirm.
6) Press Esc or the function key F5 below to return to the main interface1.
5. Press the function key F5 below to open the main interface2. Press the function
key F2 below File to display the File Manage interface1.
6. Press the function key F3 below Trans All to transmit all the files to the PC.
7. Or press F1, F2, Shift + F1 or Shift + F2 to highlight a file, and then press the function key
F4 below Select to select the file and open the File Manage interface3. Press the function key
F4 below Trans to transmit the selected file to the PC.

8.2.2 Transmitting Files Through the Net Port

1. Connect the PC to the electrocardiograph with an Ethernet cable recommended by the
manufacturer.
2. Log into the Smart ECG Viewer software.
Note: If you don't connect the net port of the electrocardiograph to the PC, or you do
not log into Smart ECG Viewer before transmission, the following hint will pop up.
3. Set the transmission mode and the IP address.
Note: If you don't set the transmission mode before transmission, the following hint will
pop up.
- 60 -