EDAN SE-601 Series User Manual page 70

the main interface2.
2) Press the function key F2 below File to open the File Manage interface1. Press the function
key F5 below
3) Press the function key F2 below AllToUSB to copy files from SE-601 to the ECGDATA
folder of the U disk. Or press the function key F3 below USBToECG to copy files from the
ECGDATA folder of the U disk to SE-601.
3. Or copy a file from SE-601 to the U disk
1) When the main interface1 is displayed, press the function key F5 below
the main interface2.
2) Press the function key F2 below File to open the File Manage interface1.
3) Press F1, F2, Shift + F1 or Shift + F2 to highlight a file, and then press the function key F4
below Select to select the file and open the File Manage interface3.
4) Press the function key F3 below To USB to copy the selected file from SE-601 to the
ECGDATA folder of the U disk.
If the U disk is not connected well, the hint U disk is not ready! will be displayed on the LCD
screen of the electrocardiograph, and then you should connect the U disk again. If it fails to
copy files, the hint file copying fails! will pop up. After the electrocardiograph successfully
copy files, the hint file copying succeeds! will be displayed.
During the copying course, if there are cognominal files in the U disk and the
electrocardiograph, the following hint (a or b) will pop up. Press Enter to close the hint. You
should remove all cognominal files from the U disk or the electrocardiograph, and then
continue to copy files.
:
CAUTION
It is forbidden to connect or disconnect a U disk or a USB printer during the copying
course.
SE-601 Series Electrocardiograph User Manual
to display the File Manage interface2.
(a)
(b)
- 63 -
to open