Transmitting Ecg Data In Dat Format Through Serial Cable; Transmitting Ecg Data Through Network; Transmitting Ecg Data In Dat Format - EDAN SE-601 Series User Manual

SE-601 Series Electrocardiograph User Manual
7.1 Transmitting ECG Data in DAT Format Through Serial
Cable
1. If the PC has RS232 socket, connect the PC RS232 socket to the electrocardiograph RS232
socket with an RS232 cable.
2. Set Auto Transmission to On and Transmission Mode to UART in the Transmission Setup
window.
3. Log into the DMS.
4. In the auto or rhythm mode, ECG data will be transmitted through the serial cable
automatically after an ECG report is printed out.

7.2 Transmitting ECG Data Through Network

7.2.1 Transmitting ECG Data in DAT Format

1. Log into the DMS.
2. Connect the electrocardiograph to the PC with an Ethernet cable recommended by the
manufacturer.
3. Configure the Transmission Setup window.
NOTE: For more information on configuring network settings, see your Network
Administrator.
For Ethernet Transmission:
1) Press Shift + F1 in the Transmission Setup window to open the Basic Setup window.
2) Set Auto Transmission to On and Transmission Mode to Wired.
3) Set the Server IP item to the IP of the PC, and FTP username and password to
EDANDAT.
For details, please refer to Section 10.5.1 "Basic Setup".
4) Press Enter to confirm, and then press Esc to return to the main screen.
For Wireless Network Transmission:
1) Press Shift + F1 in the Transmission Setup window to open the Basic Setup window.
2) Set Auto Transmission to On and Transmission Mode to Wireless.
3) Set the Server IP item to the IP of the PC.
For details, please refer to Section 10.5.1 "Basic Setup".
4) Press Shift + F2 in the Transmission Setup window to open the WIFI Setup window.
For details, please refer to Section 10.5.2 "WIFI Setup".
- 35 -
Transmitting ECG Data