Setting Ac Filter; Setting Emg Filter; Setting Dft Filter - EDAN SE-601 Series User Manual

SE-601 Series Electrocardiograph User Manual
Figure 9-5 SE-601B / SE-601C Filter Setup Interface
Figure 9-6 SE-601A Filter Setup Interface
After setup, press Enter to confirm. Then the System Setup interface appears.
For SE-601A, if you press Esc to exit the Filter Setup interface after setup, a hint will pop up to
prompt you to save these modifications.

9.2.1 Setting AC Filter

For SE-601B/C, press Tab or Shift + Tab to move the cursor to the AC Filter item on the Filter
Setup interface. Press F1 or F2 to select Off or On.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the AC Filter item on the
Filter Setup interface. Press F3 or F4 to select Off or On.
AC Filter suppresses AC interference without attenuating or distorting the ECG signals. Select
On to turn on the function and select Off to turn it off.

9.2.2 Setting EMG Filter

For SE-601B/C, press Tab or Shift + Tab to move the cursor to the EMG Filter item on the
Filter Setup interface. Press F1 or F2 to select an option.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the EMG Filter item on
the Filter Setup interface. Press F3 or F4 to select an option.
EMG Filter suppresses disturbances caused by strong muscle tremor. The cutoff frequency can be
set to 25Hz, 35Hz or 45Hz. Select Off to turn off the function.

9.2.3 Setting DFT Filter

For SE-601B/C, press Tab or Shift + Tab to move the cursor to the DFT Filter item on the
Filter Setup interface. Press F1 or F2 to select an option.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the DFT Filter item on the
- 74 -