Specifying Bp Unit; Selecting Next Patient - EDAN SE-601 Series User Manual

SE-601 Series Electrocardiograph User Manual

9.7.5 Specifying BP Unit

For SE-601B/C, press Tab or Shift + Tab to move the cursor to the BP Unit item on the Patient
Question interface, and then press F1 or F2 to select mmHg or kpa.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the BP Unit item on the
Patient Question interface, and then press F3 or F4 to select mmHg or kpa.
When BP is set to kpa, two extra edit boxes will be displayed in the Patient Information
window for inputting decimal fraction.

9.7.6 Selecting Next Patient

For SE-601B/C, press Tab or Shift + Tab to move the cursor to the Next Patient item on the
Patient Question interface, and then press F1 or F2 to select Off or On.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the Next Patient item on
the Patient Question interface, and then press F3 or F4 to select Off or On.
When Next Patient is set to On, in the AUTO mode, press the START/STOP key to print an
ECG report, and the system will automatically open the main interface3 after a complete ECG
report is printed.
Figure 9-18 SE-601B / C Main Interface3
Figure 9-19 SE-601A Main Interface3
On the main interface3, pressing the function key F1 below Same can return to the main
interface1, all the patient information will keep the same; pressing the function key F2 below
Next can return to the main interface1, all the patient information will be cleared, and the patient
ID will be refreshed; pressing the function key F3 can switch the auto style, pressing the function
key F4 can switch the paper speed, and pressing the function key F5 can switch the gain.
On the main interface3, you can print the previous ECG report again, according to the settings of
- 88 -