Lead Setup; Setting Rhythm Lead1/2/3 - EDAN SE-601 Series User Manual

SE-601 Series Electrocardiograph User Manual

9.4 Lead Setup

Press F1, F2, F3, F4, Tab or Shift + Tab to move the cursor to Lead on the System Setup
interface, and then press Enter to open the Lead Setup interface.
On the Lead Setup interface, you can set Rhythm Lead1/2/3 and Lead Sequence.
Figure 9-9 SE-601B / SE-601C Lead Setup Interface
Figure 9-10 SE-601A Lead Setup Interface
After setup, press Enter to confirm. Then the System Setup interface appears.
For SE-601A, if you press Esc to exit the Lead Setup interface after setup, a hint will pop up to
prompt you to save these modifications.

9.4.1 Setting Rhythm Lead1/2/3

For SE-601B/C, press Tab or Shift + Tab to move the cursor to the Rhythm Lead1/2/3 item on
the Lead Setup interface, and then press F1 or F2 to select an option.
For SE-601A, press F1, F2, Tab or Shift + Tab to move the cursor to the Rhythm Lead1/2/3
item on the Lead Setup interface, and then press F3 or F4 to select an option.
The rhythm lead can be one of 12 standard leads: І, П, Ш, aVR, aVL, aVF, V1, V2, V3, V4, V5,
or V6.
In the AUTO mode, when Auto Style is set to 3×4+1r or 6×2+1r, the rhythm lead selected in the
Rhythm Lead1 item will be printed in the ECG reports; when Auto Style is set to 3×4+3r, 3
rhythm leads selected respectively in the Rhythm Lead1/2/3 item will be printed in the ECG
reports.
In the RHYT mode, when Rhythm Style is set to Single Lead, 60s waveform of the rhythm lead
selected in the Rhythm Lead1 item will be printed in the ECG reports; when Rhythm Style is
- 81 -