EDAN SE-601 Series User Manual page 28

M ECG waveform
N
O
P
To Open the Main Interface3
If Next Patient is set to On, in the AUTO mode, press the START/STOP key to print ECG
reports, and the system will automatically open the main interface3 after a complete ECG report
is printed.
On the main interface3, pressing the function key F1 below Same can return to the main
interface1, and all the patient information will keep the same; pressing the function key F2 below
Next can return to the main interface1, all the patient information will be cleared, and patient ID
will be refreshed.
On the main interface3, you can print the previous ECG report again according to the set style,
paper speed and gain which are shown on the bottom of the interface. Pressing the function key
F3 can switch the auto style, pressing the function key F4 can switch the paper speed, and
SE-601 Series Electrocardiograph User Manual
File
Setup
Figure 3-5 SE-601B / SE-601C Main Interface3
Figure 3-6 SE-601A Main Interface3
Display ECG waveform
Press the function key F5 below
the main interface1
Press the function key F2 below File to open the File
Manage interface. For details, please refer to Chapter
8, "Managing Files".
Press the function key F1 below Setup to display the
System Setup interface. For details, please refer to
Chapter 9, "System Setup".
- 21 -
to return to