EDAN SE-601 Series User Manual page 68

SE-601 Series Electrocardiograph User Manual
1) When the main interface1 is displayed, press the function key F5 below to open
the main interface2.
2) Press the function key F1 below Setup to open the System Setup interface.
3) Press F1, F2, F3, F4, Tab or Shift + Tab to move the cursor. When the cursor is on
Transmission, press Enter to open the Transmission Setup interface.
4) For SE-601B/C, press F1 or F2 to select Ethernet. For SE-601A, press F3 or F4 to select
Ethernet.
5) Press Tab or Shift + Tab to move the cursor to the Remote IP item. Set the REMOTE IP
item to the local IP of Smart ECG Viewer.
6) Press Tab or Shift + Tab to move the cursor to the Local IP item. Set the first three sections
of the Local IP item to the first three sections of the local IP of Smart ECG Viewer. The last
section of the LOCAL IP item can be set at random, but it can't be the same as the last section
of the local IP of Smart ECG Viewer.
7) Press Tab or Shift + Tab to move the cursor to the Gateway item. Set the first three
sections of the Gateway item to the first three sections of the local IP of Smart ECG Viewer.
The last section of the Gateway item must be set to 001. Subnet Mask must be set to
255.255.255.000.
For example, view the local IP on the System Setting interface of the Smart ECG Viewer
software.
- 61 -