[Sense:]Event:portn:nedge:enable; [Sense:]Event:portn:pedge - Keysight E1459A User & Scpi Programming Manual

SENSe Subsystem

[SENSe:]EVENt:PORTn:NEDGe:ENABle?

Returns the decimal value of the Negative Edge Detection Mask as a 16 bit
integer.
Parameters
Comments

[SENSe:]EVENt:PORTn:PEDGe?

Returns the value of the Positive Edge Detect Register for all 16 bits of Port n.
Parameters
Comments
Keysight E1459A/Z2404B User and SCPI Programming Guide
Parameter Name Parameter Type
PORTn numeric
– Returns a number in the range of -32768 to +32767.
– Each bit enables the corresponding channel negative edge detect mask for
Port n. A 1 means the mask is enabled for that bit, a 0 means the mask is
disabled for that bit.
– *RST Condition: clears the mask (no masked bits).
Parameter Name Parameter Type
PORTn
– The value returned is in the range of -32768 to +32767. A 0 in any bit
position indicates a positive edge event was not detected for the
corresponding bit of that port; a 1 in any bit position indicates a positive
edge event was detected for the corresponding bit of that port.
– When an edge event is detected, the Edge Detect Status is set true. Refer
to the [SENSe:]EVENt:PSUM:EDGE? and [SENSe:]EVENt:PORTn:EDGE?
commands.
– Reading this register for all events that have occurred will clear the event
detector register.
– *RST Condition: disables the Edge Event.
Range of Values
0, 1, 2, 3 (PORT = PORT0)
Range of Values
numeric 0, 1, 2, 3 (PORT = PORT0)
Keysight E1459A SCPI Command Reference
Default
PORT0
Default
PORT0
61