STATus Subsystem
Comments
STATus:OPERation:PSUMmary:ENABle <mask>
Sets the value of the OPERation Status Port Summary Enable Register.
Parameters
Comments
Example
Keysight E1459A/Z2404B User and SCPI Programming Guide
– Bits 0 through 3 reflect Data Available on Ports 0 through 3 respectively;
bits 4 through 7 reflect edge events on Ports 0 through 3 respectively. See
Figure 3-1.
– Note: This command does not clear the Port summary Condition Register.
The register is cleared only by removing the the condition itself. For
example, MEAS:DIG:DATA0 will clear Bit 0 if it was set.
– *RST clears all Status Operation Port Conditions.
– *CLS does not affect the contents of the Status Operation Port Register
Conditions.
– The STAT:PRESet command does not affect the Status Operation Port
Register contents.
Parameter Name
Parameter Type
<mask>
numeric
– This mask determines which Operation Status Port Summary Events are
summed and reported in bit 9 of the Operation Status Register. Bits 0
through 3 reflect Data Available on Ports 0 through 3 respectively; bits 4
through 7 reflect edge events on Ports 0 through 3 respectively. See Figure
3-1.
– *RST and *CLS do not affect the value of the enable mask.
– STATus:PRESet sets the value of the enable mask to 0.
STAT:OPER:PSUM:ENAB 0xFFFF
Keysight E1459A SCPI Command Reference
Range of Values
-32768 to 32767 (0000
to FFFF
h
Enables all bits of the Operation
Status Port Summary Enable Register
Default
)
0
h
69