Automatic Gap Adjustment (Aga); Direct Setting Of The Print Head Distance - TallyGenicom Matrix Printer Programmer's Manual

Automatic Gap Adjustment (AGA)

Direct Setting of the Print Head Distance

Data Structure ASCII
hex.
dec.
ASCII
hex.
dec.
Description
Setting the print head distance accords to the respective paper path selected. Unit, adjust
range and default setting depend on the device used.
If the Automatic Gap Adjustment is set to ON, the sequence
70
Miscellaneous
CSI n "+"
9B n 2B
155 n 43
CSI n "+"
9B n 2B
155 n 43
For the sequence CSI n + z the following parameters are available for n:
n hex. dec.
0 30 48
1 31 49
For the sequence CSI n + y the following parameters are available for n:
n hex. dec.
0 30 48
n
Example:
Settings of T2060:
"z" [B] automatic gap adjustment
7A
122
"y" [B] direct setting of the print head distance
79
121
Adjustment (automatic)
automatic adjustment OFF
(print head distance must be set at the printer)
automatic adjustment ON
Setting (direct)
Default value
(is set at the printer)
print head distance in n -steps
Unit = 10 Micrometers
Adjust range = 1 – 100
Default value = 18
CSI ... + z
CSI ... + y
is ignored.