Superscript/Subscript - TallyGenicom Matrix Printer Programmer's Manual

Superscript/Subscript

Command Description
ESC K SUBSCRIPT PRINTING
(PLD) Moves paper 1/2 line below the current line for subscript printing. ESC K is used to
return to the original line following ESC L (superscript).
If 8-bit control code processing is enabled then
Dec 139
otherwise
Dec 27 75
ESC L SUPERSCRIPT PRINTING
(PLU) Moves paper 1/2 line above the current line for superscript printing. ESC L is used to
return to the original line following ESC K (subscript).
If 8-bit control code processing is enabled then
Dec 140
otherwise
Dec 27 76
NOTE: The partial line up does not respect top of form; that is, following a form feed, ESC L causes a partial line
movement upward. Also, partial line down does not respect bottom of form; that is, when printing the last line on
the form, ESC L causes a partial line movement downward.
When printing the last line on a form, do not send a line feed (LF) code to move directly from superscript to
subscript. The LF code will be acted upon as the bottom of form terminator.
7265 Programmer's Manual
Copyright © 2004 TallyGenicom
Hex 8B
Hex 1B 4B
Hex 8C
Hex 1B 4C
21
Chapter 2 ANSI