Character Density 10 Cpi; Character Density 12 Cpi; Character Density 15 Cpi - TallyGenicom Matrix Printer Programmer's Manual

Character Density 10 cpi

Character Density 12 cpi

Character Density 15 cpi

Data Structure ASCII
hex.
dec.
ASCII
hex.
dec.
ASCII
hex.
dec.
–
Description This code sequence sets the character density to 10 cpi (Pica). This is also the default
character density.
—
This code sequence sets the character density to 12 cpi (Elite).
˜
This code sequence sets the character density to 15 cpi. With this code sequence not
only the character spacing is altered, but also the size of the characters (approx. 2.3
mm high and 1 mm wide). That is why the font set with this sequence is referred to as
microfont.
All three control codes neutralise each other.
If the character spacing is changed using one of the sequences – with proportional
spacing selected this change only becomes effective when the printer leaves the
proportional mode.
ESC "P" set character density to 10 cpi (Pica)
1B 50
27 80
ESC "M" set character density to 12 cpi (Elite)
1B 4D
27 77
ESC "g" set character density to 15 cpi
1B 67
27 103
ESC P
ESC M
ESC g
–
—
˜
21
Character Spacing