Signification Des Symboles - Otto Bock 12S6 L Instructions For Use Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 12
4) Loosen the four screws (Fig. 18), remove (Fig. 19) and dispose of them.
5) Remove the steel bracket by pulling it downwards (Fig. 20).
6) Put the new O-rings over the steel bracket (Fig. 21).
7) Place the steel bracket on the shoulder bracket (Fig. 22) and pull the O-rings onto the des-
ignated position.
8) Apply Loctite® 241 (636K13) to the upper half of the large, middle screw only (Fig. 23). Do
not apply any adhesive to the lower half of the screw. Apply a thin coat of adhesive to the
thread of the other three screws as well (Fig. 23).
9) Insert the screws (Fig. 24) and tighten them with an installation torque of 2 Nm (Fig. 25).
5 Liability
Ottobock Healthcare GmbH, hereafter referred to as manufacturer, assumes liability only if the
user complies with the processing, operating and maintenance instructions as well as the service
intervals. The manufacturer explicitly states that this product may only be used in combination with
components that were authorized by the manufacturer (see instructions for use and catalogs). The
manufacturer does not assume liability for damage caused by component combinations which it
did not authorize.
The product may only be opened and repaired by authorized Ottobock technicians.
6 CE conformity
This product meets the requirements of the 93/42/EWG guidelines for medical products. This
product has been classified as a class I product according to the classification criteria outlined
in appendix IX of the guidelines. The declaration of conformity was therefore created by Ottobock
with sole responsibility according to appendix VII of the guidelines.
INFORMATION
Date de la dernière mise à jour : 2014-07-10
• Veuillez lire attentivement l'intégralité de ce document.
• Respectez les consignes de sécurité.

Signification des symboles

Mises en garde contre les éventuels risques d'accidents et de blessures graves.
AVERTISSEMENT
Mises en garde contre les éventuels risques d'accidents et de blessures.
ATTENTION
Mises en garde contre les éventuels dommages techniques.
AVIS
Autres informations relatives à l'appareillage / l'utilisation.
INFORMATION
Les éléments livrés sont représentés sur la couverture.
16 | Ottobock
Français
12S6=L/R

Advertisement

Table of Contents
loading

This manual is also suitable for:

12s6 r

Table of Contents