1. Overview and connection technology I/O modules
1.3.2 Fitting the screening/shield plates
Fitting
Dismantling
1−24
A screening/shield plate type CPX−AB−S−4−12 can be fitted on
sub−base CPX−AB−4−M12x5−5POL. The sub−base must be
removed before the terminal is fitted or dismantled.
Fit the screening/shield plate as follows (see Fig. 1/8):
1. Dismantle the sub−base (see section 1.3.1).
2. Snap the spring clips of the screening/shield plate from
above into the appropriate recesses on the dismantled
sub−base.
3. Fit the sub−base
Instructions on earthing the screening/shield plate can be
found in section 1.2.3.
The screening/shield plate should be removed in the
opposite sequence to the fitting procedure.
Festo P.BE−CPX−AX−EN en 0503b