Festo CPX-AB Series Electronic Manual page 40

1. Overview and connection technology I/O modules
Dismantling
1
Sub−base
2
Screws
3
Electrical plug
connector
4
Electronic
module
5
Contact rails
6
Manifold
sub−base
Fig. 1/7: Fitting/removing the I/O module
1−22
Dismantle the sub−base as follows (see Fig. 1/7):
1. Loosen the 4 screws in the relevant sub−base with a Torx
screwdriver size T10.
2. Pull the sub−base carefully and without tilting away from
the electrical plug connection of the electronic module.
Only in cases where the electronic module is to be removed:
Pull the electronic module carefully and without tilting
·
away from the contact rails of the manifold sub−base.
1
3
Festo P.BE−CPX−AX−EN en 0503b
2
4
5
6