Festo CPX-AB Series Electronic Manual page 208

A. Technical appendix
Technical specifications Technical specifications
Analogue outputs (cont.)
Interference suppression
Crosstalk between outputs
Permitted potential differences
between the output channels
between OGND and FE
Fault limits
Operating fault limit (T
Basic fault limit (25 °C)
Temperature fault
Linearity fault (without scaling)
Repetition accuracy at 25 °C
Specifications on sensor selection
Load resistance ...
for ohmic load
for capacitive load
for inductive load
short−circuit protection
short circuit current
idling voltage
Destructive limit against voltages
applied externally
Connecting the actuators
Actuator supply
Load capacity
Fuses
Response current
Reaction after end of overload
Protection against incorrect polarity 24 V
actuator supply
Protection against reverse voltage
Electrical isolation
Between channel and 24 V
Between the channels
Module code (CPX−specific)
Module identification (handheld)
A−10
CPX−2AA−U−I
Voltage outputs
Min. −40 dB
0 V AC
30 V DC
...T ) ± 0.6 %
min max
± 0.5 %
± 0.015 % / K
± 0.1 %
0.05 %
Min. 1 k
Max. 1 F
Yes
Approx. 20 mA
Max. 30 V lasting
2 conductor connections
24 V
the same supply potential at all outputs
Max. sum continuous current per module: 2.8 A
Electronic, thermal
4 ... 10 A
Can be parametrized (see parameters)
Yes
Max. 30 V
The logic supply of the electrically isolated analogue
part is branched from the analogue voltage which is
generated by a DC−DC converter from the 24 V
Yes (no potential isolation if internal actuator supply is
OUT
used)
No
129
2AO
, one connection per analogue output,
OUT
Current outputs
± 0.6 %
± 0.5 %
± 0.015 % / K
± 0.1 %
0.05 %
Max. 600
Max. 1 mH
18 V
Max. 30 V lasting
2 conductor connections
EL/SEN
Festo P.BE−CPX−AX−EN en 0503b
.