gefran ADV200 Functions Description And Parameters List page 68

Note !
The value that is obtained automatically can be changed manually, if necessary, using An inp offset xX.
If the voltage setting on the analog input is higher than 1V, the Value too low alarm is generated.
Menu PAR Description
14.37 1608 An inp 1X gain tune
14.48 1658 An inp 2X gain tune
Self-tuning command for the relative analog input gain. Automatic fine tuning of the input. When this command
is sent, Analog inp 1 gain x is automatically selected so that the available input signal corresponds to the
maximum value of the variable.
Two conditions are necessary in order to perform automatic tuning:
- Input voltage greater than 1V or input current greater than 2 mA
- Positive polarity. The value that is found is automatically accepted for the other direction of rotation.
Note ! If necessary, the value obtained automatically can be changed manually via Analog inp Xx gain.
To perform self-tuning, set the input signal to its maximum value and execute the command. A multiplier factor
is calculated to apply to the input signal value (not considering the Analog inp scale parameter) to reach the
full scale value.
If the voltage setting on the analog input is less than 1V, the Value too low alarm is generated.
Menu PAR Description
14.38 1612 Analog inp 1X top
14.49 1662 Analog inp 2X top
Setting of the upper speed reference limit as a function of the voltage (or current) of the relative analog refer-
ence of the expansion card.
Menu PAR Description
14.39 1614 Analog inp 1X bottom
14.50 1664 Analog inp 2X bottom
Setting of the lower speed reference limit as a function of the voltage (or current) of the relative analog refer-
ence of the expansion card.
Menu PAR Description
14.40 1616 Analog inp 1X offset
14.51 1666 Analog inp 2X offset
Setting of an offset value to algebrically add to the relative analog input of the expansion card.
Menu PAR Description
14.41 1618 Analog inp 1X gain
14.52 1668 Analog inp 2X gain
68
UM Type FB BIT
BIT
BIT
UM Type FB BIT
cnt INT16
cnt INT16
UM Type FB BIT
cnt INT16
cnt INT16
UM Type FB BIT
cnt INT16
cnt INT16
100%
{
Analog inp xX offset
0
UM Type FB BIT
FLOAT
FLOAT
Def Min
0 0
0 0
Def Min
16384 -32768
16384 -32768
Def Min
-16384 -32768
-16384 -32768
Def Min
0 -32768
0 -32768
10V
Def Min
1.0 -20.0
1.0 -20.0
ADV200 • Functions description and parameters list
Max Acc Mod
1 RWZ FVS
1 RWZ FVS
Max Acc Mod
+ 32767 ERW FVS
+ 32767 ERW FVS
Max Acc Mod
+ 32767 ERW FVS
+ 32767 ERW FVS
Max Acc Mod
+ 32767 ERW FVS
+ 32767 ERW FVS
Max Acc Mod
20.0 ERW FVS
20.0 ERW FVS