Quantum F2000 User Manual page 45

Figure 22 F2000 Rear View -
IPMI/BMC Port on Canister A
Quantum F2000 User's Guide
Item
1 IPMI/BMC port on the bottom canister
2 IPMI/BMC port on the top canister
Configure Laptop Network Settings for Direct Connections
Complete one of the following two procedures, depending on whether
you are using a Windows or Mac notebook computer.
For Windows
This procedure assumes you are running Windows 10 on your notebook
computer. The steps might be different if you are using another
operating system.
1 On your notebook computer, access the Network and Sharing
Center control panel. To do this, press the Windows key on the
keyboard, type "view network status and devices" and press Enter.
2 On your notebook computer, access the Network and Sharing
Center control panel. To do this, press the Windows key on the
keyboard, type "view network status and devices" and press Enter.
3 Click Change adapter settings.
4 Right-click the network connection that corresponds to the Ethernet
port on your notebook computer (for example, Ethernet), and click
Properties.
5 Select Internet Protocol Version 4 (TCP/IPv4) in the list of
connections, and then click Properties.
Chapter 3: F2000 Basic Operations
Use the BMC Web UI
Description
31