Quantum F2000 User Manual page 111

Figure 91 IPMI/BMC Port
Location on the Top Canister
Quantum F2000 User's Guide
Verify the System is Up and Running
To verify the system:
1 Using a CAT6A Ethernet cable, connect a notebook computer to the
IPMI/BMC port on the top canister (see
Item
1 IPMI/BMC port on the top canister
2 Access the BMC Web UI.
Note: For instructions on how to access the BMC Web UI, refer to
Access the BMC Web UI
Operations.
3 On the BMC Web UI, verify that the canister does not report any
errors.
Note: Refer to
Check the Status of a Canister
Check the System Inventory of a Canister
Chapter 3, F2000 Basic Operations
to check for errors.
4 Disconnect the CAT6A Ethernet cable from the IPMI/BMC port on
the top canister.
5 Connect the CAT6A Ethernet cable to the IPMI/BMC port on the
bottom canister (see
Chapter 4: F2000 Customer Replaceable Units (CRUs)
Figure
Description
on page 30
Figure 92 on page 98).
Chassis Replacement
91).
Chapter 3, F2000 Basic
on page 49 and
on page 50 in
for instructions on how
97