Quantum F2000 User Manual page 194

Chapter 4: F2000 Customer Replaceable Units (CRUs)
SSD Assembly Replacement
180
4 Access the Appliance Controller Console and attach the new drive to
the system by running the following command:
# qstorage drive attach auto
The system identifies the new drive and attaches it. It returns the
following message if the drive attachment was successful:
All new drives were successfully added
After the drive is replaced and the qstorage drive attach auto
command is run, rebuilds for the arrays occur in parallel.
5 Run the following command to show the status of the drive
recovery operation:
# qstorage show health
Quantum F2000 User's Guide