Chapter 3: F2000 Basic Operations
Use the BMC Web UI
32
6 Select Use the following IP address and then enter the following
information:
• IP address: 192.168.17.10
• Subnet mask: 255.255.255.0
7 Click OK, and then click Close.
Wait at least two minutes for the computer to set the IP addresses
on the local computer.
For Mac
The following procedure assumes you are using a Mac. Steps may differ
for your system, depending on your macOS version.
1 Select the Apple menu > System Preferences> Network, and
select the Ethernet connection.
In the Configure IPv4 drop-down list, select Manually.
2 Enter the IP address and subnet mask values (leave gateway blank):
• TCP/IPv4 address: 192.168.17.10
• Subnet mask: 255.255.255.0
3 Click Apply.
4 Close the Network dialog.
Wait at least two minutes for the laptop to enable the network
connection.
Log Into the BMC Web UI
1 On the notebook computer, open a supported Web browser and
type https://192.168.17.21 in the address box, and press Enter.
Note: You must use "https://" the first time you access the BMC
Web UI through the IPMI/BMC port.
Quantum F2000 User's Guide