Pausing The Video Rendering; Settings For Alarm Preview Pane; Figure 5-14 Settings For Pausing The Video Rendering - Honeywell MAXPRO NVR Hybrid XE Installation And Configuration Manual

Pausing the Video Rendering

Settings for Alarm Preview Pane

MAXPRO NVR 5.6 Installation and Configuration Guide
You can pause the video rendering to momentarily stop the rendering of video when a tab that
does not display video is selected (for example, when the Report tab is selected, the video
rendering can be paused to improve the application performance). The rendering of video
starts again when you select a different tab in the user interface.
To select the tab which pauses video rendering
1. Click the Preferences option in the User menu,
appears. By default, the General Settings tab is selected.
2. For Pause Video Rendering, select the check box next to the tab names that you want to
select (Figure 5-14).
Figure 5-14 Settings for pausing the Video Rendering
3. Click Apply.
4. Click OK to close the dialog box.
When the video related to an alarm is played from the Alarm window, the salvo layout
changes to a four panel layout. You can define the video display for each panel namely, Pre
Alarm, Post Alarm, Live, and On Alarm. The following table defines these options.
Option Description
Pre Alarm The video before the occurrence of the event that triggered the
alarm is played.
Post Alarm The video after the occurrence of the event that triggered the alarm
is played.
Live Live video is played.
On Alarm The video is played from the occurrence of the event that triggered
the alarm.
Note:
You can view video related to alarms for the cameras connected to MAXPRO
NVR. For Pre Alarm, Post Alarm, and On Alarm, the video is played only when the
video recording pertaining to the date and time of alarm is available.
To define the video display for each preview panel
L O G G I N G O N A N D G E T T I N G S T A R T E D
Setting Preferences
. The Preferences dialog box
109