Figure 6-15 Adding Stream - Honeywell MAXPRO NVR Hybrid XE Installation And Configuration Manual

C O N F I G U R I N G M A X P R O N V R
6
Configuring the Cameras
3.
Figure 6-15
Note:
4.
5.
148
Click the Add Stream button, an additional stream (Stream 2) is added see
Adding Stream
• Based on the type of camera the Add Stream button is enabled/disabled. If
the camera supports additional streams then the Add Stream button is
enabled. You can add streams until the button is enabled.
• System stream limit is 128. This is the maximum number of streams that can
be added including multi-stream for cameras and multi-channel encoders or
multi-imager 180/360 cameras. Multistream or Dual stream is not supported
for encorders.
Under Stream 2:
• Type the required Name for the additional stream.
• Select Enable Stream check box to enable the stream Or clear the check box to
disable this stream.
For the Stream 2 Recording, Schedules, Preference settings, repeat
step 10 of Configuring the Camera Properties
and configure multiple streams for a camera.
step 6
section on page 141. Similarly you can add
MAXPRO NVR 5.6 Installation and Configuration Guide
Figure 6-15.
through