Honeywell MAXPRO NVR Hybrid XE Installation And Configuration Manual page 139

MAXPRO NVR 5.6 Installation and Configuration Guide
• For fresh installation of 4.0 we recommend the Unique System Number
should be updated when the camera is added to the NVR system. If the
Unique System Number is modified later then the older recording cannot be
retrieved.
• Unique system Number can be discovered as callup number in VMS based
on the user configuration in VMS discovery window.
• Stream Count - Displays the number of streams associated with the camera. By
default it displays 1. if a additional stream is added then the stream count increases.
Multistream or Dual stream is not supported for encorders.
• NVR System Load, Storage Calculator -
• NVR System Load provides system load estimate based on the estimation of
recording bit rate of cameras currently configured on your NVR versus
maximum recording bit rate supported for the NVR in graphical manner
(Percentage load is displayed and the indicator changes to red if the load is
above the limit).
Tip: Hover the mouse over the NVR System Load indicator for more details.
Note:
• Part Number of your NVR system should be entered in the System tab for the
Maximum estimate to be shown in the System Load. Please reopen the NVR
client after updating the part number, if the part number is updated after
opening the client.
• NVR System Load is based on the recording bit rate only and does not
include archival recording.
• Maximum Bit Rate is based on the part number entered in System tab and
Current Bit Rate Estimate is based on the cameras configured in the NVR.
• For Software only NVR System, 4 Mbps bit rate per camera license is
assumed to calculate the Maximum Bit Rate but the maximum bit rate
supported can vary based on your NVR Server hardware specification.
• The Current Bit Rate Estimate is based on the estimated bit rate value for
configured cameras based on standard conditions and can vary based on
your site environment. All the estimated bit rate calculations are based on
fixed bit rate (Mbps) and might vary based on the site environment if the
camera is set to VBR (variable bit rate) mode.
• It is very important to stay within the estimator guidelines to ensure the
MAXPRO NVR will operate normally.
C O N F I G U R I N G M A X P R O N V R
Configuring the Cameras
139