How To Get/Configure Annotation Feature; Install The Va Packages - Honeywell MAXPRO NVR Hybrid XE Installation And Configuration Manual

How to get/configure Annotation Feature

Upgrade the Camera Firmware

Install the VA packages

Remove Old VA Package
MAXPRO NVR 5.6 Installation and Configuration Guide
To get and use the Annotation feature in MAXPRO NVR/VMS, user needs to perform the
following configurations in the order as mention below:
1. Upgrade the Camera Firmware
2. Install the VA packages
a. Remove Old VA Package
b. Upgrade to Latest VA Package
3. Obtain the License to use Annotation feature
4. Configure and Enable Annotation in NVR
5.
Enable Annotations in VMS
1. Launch the Equip-S series model camera web page and then click on Setup tab.
2. Check the existing version of Firmware in Information > Version page.
3. In the left pane, navigate to System Setup > Upgrade. The Firmware Upgrade page is
displayed as shown below.
4. Click the Import button and then browse the Firmware to import.
5. Click Upgrade. Once the upgrade complete, Firmware Upgrade successful message is
displayed.
If the existing VA package is old then:
1. Navigate to Video Analytics > Smart Plan. The Smart Plan page is displayed.
C O N F I G U R I N G M A X P R O N V R
Annotations
221