Adding Additional Streams For A Camera; Figure 6-14 Camera Properties Pane - Honeywell MAXPRO NVR Hybrid XE Installation And Configuration Manual

Adding Additional Streams for a Camera

MAXPRO NVR 5.6 Installation and Configuration Guide
Note:
You cannot edit the Camera Type field. The cameras credentials settings
provides the username and password for Honeywell (for models already added
in NVR database), AXIS (for models already added in NVR database) and ONVIF
cameras discovery and addition. If a Honeywell or AXIS ONVIF model that is not
already added in NVR database is discovered, then the camera credentials set
for ONVIF is used for discovery and addition. You can find all the models that are
already added in NVR database by checking the models listed in the Camera
Type drop-down in the Camera tab.
• Click Apply to save the changes or click Reset to clear the information entered.
The username and password entered is applicable for all NTSC or PAL cameras.
However, the username and password can be changed while configuring a
particular camera.
MAXPRO NVR V4.0 supports adding multiple streams for a single camera. The number of
streams that can be added depends on the model of the camera. You can also configure each
stream for a specific device based on your need. For example you can configure the first
stream for Live recording and the second stream for event based recording. Multistream or
Dual stream is not supported for encoders.
To configure the additional streams for a camera
1. Click the Camera tab, the camera page is displayed with the list of cameras discovered.
2. For the required camera, click
displayed see Figure 6-14.
Figure 6-14 Camera Properties Pane
C O N F I G U R I N G M A X P R O N V R
Configuring the Cameras
on the left corner, the camera properties pane is
147