How to configure the Archival and Deletion retry
settings
Recommendations:
MAXPRO NVR 5.6 Installation and Configuration Guide
Honeywell recommends before configuring Archival Clip and Deletion Retry settings ensure
that the following parameters are set based on the site requirement:
•
The default value for DiskAlarmThresholdInGB is 100: This indicates when the
available free space in archival location is less than 100 GB then an alarm is
triggered.
•
The default value for DiskRecyclingInGB is 30: This indicates if the available free
space is below 30 GB, then the older archived clips are recycled to create space for
the newly archiving clips.
•
The default value for DiskSwitchLimitINGB is 5: This indicates if the available free
space in the archival location goes less than 5 GB then Low Disk Space alarm is
triggered and the archival process will be attempted to next available archival
location if configured.
1.
Navigate to C:\Program Files
(x86)\Honeywell\MaxproNVR\TrinityFramework\bin\TrinityArchival.exe.config.
2.
Right-click and open with Notepad.
3.
Scroll down to locate the below two values and change the count value for each
parameter based on the requirement. The default value is 4.
•
If Value is set to 0 = Indefinite tries
•
If Value is set to > than 0 = Indicated the number of attempts to archive or
delete the archived clips respectively.
Note:
Archival/Deletion Retry settings will be moved to default count value if user
upgrades to future versions of VMS/NVR.
C O N F I G U R I N G M A X P R O N V R
Guidelines to configure NAS Drive for Recording
219