Looping Output Termination; Figure 3-12 Looping Output Termination - Honeywell MAXPRO NVR Hybrid XE Installation And Configuration Manual

Looping Output Termination

MAXPRO NVR 5.6 Installation and Configuration Guide
The video inputs are 75 Ώ BNC connectors. Plug one end into the video source
Note:
(DVD, Camera, etc.) and plug the other end into the desired BNC input on the
NVR.
If the image appears distorted or virtually un-viewable, turn the termination resister to the ON
position, making it terminated. When it is necessary to terminate a looping output, the NVR
has built-in termination that allows users to select individual outputs. It is not always necessary
to terminate the output; it depends on the device to which you are connecting. As a rule, if the
image appears distorted or virtually un-viewable, it likely needs to be terminated.
Note:
Please refer to the specific Hybrid unit data sheet for more information on number
of looping outputs supported on a specific unit.
Figure 3-12 Looping Output Termination
Note:
Always leave the dip switch set to the ON position when the Looping Outputs are
not used and only the installer should decide to turn it ON /OFF.
S E T T I N G U P T H E M A X P R O N V R
MAXPRO NVR Hybrid Connections
67