Honeywell MAXPRO NVR Hybrid XE Installation And Configuration Manual page 196

C O N F I G U R I N G M A X P R O N V R
6
Automatic Retry for Backfilled Clips
3.
Parameter Value to change
"DownloadRetryCount" value="0"
"FailClip_RetryInterval" value="06:00"
"FailClip_RetryCount" value="3"
"FailClip_ConfigRefreshInterval" value="1"
"FailClip_StartTimeOnServiceStart"
value="00:00"
"NoOfFailedClipsPerBatch" value="10"
"ClipDownloadTimeoutMultiplier"
value="1.5"
4.
196
Change the values as mentioned in the below table. The values shown below are default
values and user can change based on there requirement.
Immediate number of consecutive retries for a failed clips.
Number of Schedule retries the pooling interval. The default value
is set to 6 hours. For every 6 hours once MAXPRO NVR will retry to
download the failed clips
Number of Schedule retries for automatic retry. The default value is
set to 3. For example if the clip is failed, the first retry is attempted
after 6 hours consecutively for 3 times.
This key helps user to set the configuration change refreshing
interval for above auto retry changes. For example: FailClip_Retry-
Interval value change will be activated after ConfigRefreshInterval
time reaches without service restart. The default value is set to 1
second.
This key will decide from when the Fail Retry should start after
starting the service. This is the reference point to FailClip_RetryIn-
terval" value. Retry operation triggers after StartTimeOnService-
Start value.
Number of clips to retry with a given camera before attempting the
retry on another cameras. Once all the cameras are done with
retry then the control comes back to the first camera and fetches
the number of clips mentioned for retry.
A Multiplier factor to the Maximum Time (actual Clip playback
duration or 10min, whichever is higher) until that the backfill ser-
vice waits to Timeout for downloading a clip.
Click Close to close the config file.
Description
MAXPRO NVR 5.6 Installation and Configuration Guide