Honeywell MAXPRO NVR Hybrid XE Installation And Configuration Manual page 227

Configuring Loitering trace
Pre-requisite:
MAXPRO NVR 5.6 Installation and Configuration Guide
area, Minimum speed, Maximum speed, Time and Distance acceptance, minimum time
and minimum distance.
7. Click Save at the bottom of the page. Data Saved successfully message is displayed.
8. Click on Parameters and set the parameter for all the defined zones as shown below.
9. Click Save at the bottom of the page. Data Saved successfully message is displayed.
10. Click on the Live tab to view the configured intrusion feature.
Before you configure the Loitering trace feature ensure you have:
Upgraded the camera firmware
a.
Upgraded the Loitering trace VA package
b.
Obtained and installed the required license.
c.
1. Click on the Configure tab, the Configure page is displayed as shown below. By default
the Calibrate tab is selected.
C O N F I G U R I N G M A X P R O N V R
Annotations
227