A P P E N D I X B
B
VMD Settings and Motion-based Recording Configuration
Configuring the Pre and Post Event Recording
Se ttings
See the
the pre and post event recording settings.
Configuring Camera Settings for VMD-Based
Re cordi ng
1.
Figure B-2
Note:
330
Event Recording Settings
Click the Configurator tab and then the Camera tab to open the Camera configuration
page
(Figure
B-2).
Camera configuration page
•
For built-in (Camera-based) VMD configuration, open the camera web page by
clicking Launch Web View for Advanced Setup. See the
(Camera based VMD) on Honeywell IP Cameras
information.
•
For Server-based VMD (SMART VMD) configuration, select the Enable SMART VMD
check box and click Configure. See the
page
331
for more information.
Built-in (Camera-based) VMD support in NVR is based on the type of device
integration and may not be supported for all devices. Please refer to the MAXPRO
NVR compatibility list on HOTA website
(http://www.security.honeywell.com/hota/) for details. Server VMD (SMART VMD)
is supported for all video devices supported by NVR.
section on page
128
for more information on configuring
section on page
Server VMD (SMART VMD)
MAXPRO NVR 5.6 Installation and Configuration Guide
Configuring Built-in VMD
331
for more
section on