Using The Optional Mod (Magneto-Optical Drive) - GE Voluson 730Pro Service Manual

GE H - K
EALTHCARE RETZTECHNIK
D , R
IRECTION EVISION
4-4-11

Using the optional MOD (Magneto-Optical Drive)

The MOD (Magneto-Optical Drive) is an Option.
NOTICE
!! NOTICE:
The optional 3.5 inch Magneto-Optical disk drive supports the following medias:
1.3GB; 640MB; 540MB; 230MB and 128MB
Magneto-Optical Drive
(MOD)
1.) Before installing an MO disk in the MOD, check the MO disk for loose hardware or damaged labels
which could jam inside the MOD. Also, ensure that the slide switch in one corner of the disk is set
so that the disk is write enabled (disk hole closed).
2.) Insert the disk into the MOD with the label facing up.
Never move the unit with a disk in the MOD because the drive actuator will not be locked and
NOTICE
the MOD could break.
!! NOTICE:
3.) There are different methods to eject a disk from the MOD. Manual ejection methods are listed below
in preferred order from best (1) to worst (3).
a.) Press the EJECT switch on the MOD while system is ON.
b.) Press and hold the EJECT switch while the system is booting.
c.) Mechanical ejection. Insert the end of a paper clip into the hole next to the EJECT switch while
Avoid mechanical ejection whenever possible. Mechanical ejection leaves the actuator
NOTICE
unlocked and the MOD susceptible to damage if moved. If forced to use this method, reboot
!! NOTICE:
the system, then insert and eject a known good disk using one of the other manual ejection
methods.
DRAFT (A
Figure 4-14 Magneto-Optical Drive
system power is OFF.
Chapter 4 - Functional Checks
28, 2008)
PRIL
V ® 730P / P
OLUSON RO RO
S
ERVICE
Eject Button
V (BT03)
M
ANUAL
4-27