GE Voluson 730Pro Service Manual page 34

GE H - K
EALTHCARE RETZTECHNIK
D 105910, R
IRECTION EVISION
Table 1-5
LABEL/SYMBOL
1-6
3 DRAFT (A
Product Icons (Continued)
PURPOSE/MEANING
"Mains OFF" Indicates the power off position of the mains power
switch.
"OFF/Standby" Indicates the power off/standby position of the
power switch.
CAUTION
This Power Switch DOES NOT ISOLATE Mains Supply
"Mains ON" Indicates the power on position of the mains power
switch.
ON switch of the isolation transformer for auxiliary devices.
OFF switch of the isolation transformer for auxiliary devices.
"Protective Earth" Indicates the protective earth (grounding)
terminal.
"Equipotentiality" Indicates the terminal to be used for connecting
equipotential conductors when interconnecting (grounding) with
other equipment.
DANGEROUS ELECTRIC VOLTAGE.
Pull the mains plug before opening the unit!
Waste Electrical and Electronic Equipment (WEEE) Disposal.
This symbol indicates that waste electrical and electronic
equipment must not be disposed as unsorted municipal waste
and must be collected separately. Please contact an authorized
representative of the manufacturer for information concerning the
decommissioning of your equipment.
These symbols indicate that at least one of the six hazardous
substances of the China RoHS Labelling Standard is above the
RoHS limitation.
The number inside the circle is referred to as the Environmental
Friendly Use Period (EFUP). It indicates the number of years that
the product, under normal use, will remain harmless to health of
humans or the environment.
EFUP = 10 for Short Use Products
EFUP = 20 for Medium Use Products
Section 1-2 - Important Conventions
28, 2008)
PRIL
V ® 730P / P
OLUSON RO RO
S
ERVICE
LOCATION
Rear of system at mains switch (F1)
Adjacent to On-Off/Standby switch left
below the Control panel.
Rear of system at mains switch (F1)
Rear of system at the switch for auxiliary
devices (F2)
Rear of system at the switch for auxiliary
devices (F2)
Internal, Rear of Power Supply
Rear of Power Supply
Rear of Power Supply
(if "new" version of CPN80-81 is installed)
Rear side of the unit
on the plug of each probe
(availability depends on delivery status)
Rear side of the unit
on the plug of each probe
(availability depends on delivery status)
V (BT03)
M
ANUAL