Sub Menu - GE Voluson 730Pro Service Manual

GE H - K
EALTHCARE RETZTECHNIK
D , R
IRECTION EVISION
4-4-5-3

Sub Menu

Table 4-9
Step
1
2
3
4
5
6
7
8
For further details refer to the Voluson® 730Pro / ProV Basic User Manual, Chapter 11.
DRAFT (A
Figure 4-12 3D/4D Sub Menu
Sub Menus
Task
To select the desired Render View Direction (green line symbolizes direction of the view).
RENDER VIEW
DIRECTION
Note: The Render View Direction keys are not available in Static 3D Sectional Planes.
GRAY/CHROMA Depending on individual requirements a "harder" or "softer" image can be obtained.
Adjusts the contrast of the screen background from dark to bright.
BACKGR.
Note: This key is not available in Static 3D Sectional Planes mode.
To set the start point of the gamma curve bending. (Graphic display on screen)
CONTR. POS
Note: This key is not available in Static 3D Sectional Planes mode.
To set the contrast of the bending. (Graphic display on screen)
CONTRAST
Note: This key is not available in Static 3D Sectional Planes mode.
Only available if a 3D+CFM or a 3D+PD image is acquired.
POWER THRESH.
Note: This key is only available if a 3D+CFM or a 3D+PD image is acquired.
Only available if a 3D+CFM or a 3D+PD image is acquired.
BALANCE
Note: This key is only available if a 3D+CFM or a 3D+PD image is acquired.
3D/4D INFO On/Off switch to show full or reduced image Info parameter on screen.
Chapter 4 - Functional Checks
28, 2008)
PRIL
Expected Results
V ® 730P / P
OLUSON RO RO
S
ERVICE
V (BT03)
M
ANUAL
4-19