Power Off/ Shutdown; Back-End Processor Power Down; Scanner Shutdown - GE Voluson 730Pro Service Manual

GE H - K
EALTHCARE RETZTECHNIK
D , R
IRECTION EVISION
3-6-3

Power Off/ Shutdown

After turning off a system, wait at least 10 seconds before turning it on again.
NOTICE
The system may not be able to boot if power is recycled too quickly.
!! NOTICE:
3-6-3-1

Back-end Processor Power Down

1.) Press the ON/OFF Standby switch left below the Control Panel; see:
3-6-3-2

Scanner Shutdown

1.) Press the ON/OFF Standby switch left below the Control Panel.
2.) Switch OFF the Circuit Breaker at the rear of the system.
NOTE: The mains outlet of the system for peripheral auxiliary equipment are commonly switched with the
Standby switch. So the auxiliary equipment need not to be switched ON/OFF separately.
Disconnection of the Main Power Cable is necessary!
WARNING WARNING
For Example: When repairing the system.
!! WARNING:
3.) After complete power down, unscrew the 2 screws and remove the pull-out protection to disconnect
the main power cable from the system or unplug it from the AC wall outlet socket.
Circuit Breaker
Mains Power Cable
Figure 3-24 Circuit Breaker, Protection and Power Cable on back of Voluson® 730Pro / ProV
4.) Press once on the brakes to block the front wheels (brakes on front wheels under the foot rest).
5.) Prior to disconnect a probe freeze the image.
6.) Disconnect probes. (Turn the probe locking handle counterclockwise and then pull the connector
straight out of the probe port.)
7.) If required, open the right-hand side door, remove the probe cable from the cable holder and then
close the door.
DO NOT disconnect a probe while running (Live Scan "Write" mode)!
CAUTION
A software error may occur. In this case switch the unit OFF (perform a reset).
!! CAUTION:
3-24
DRAFT (A 28, 2008)
PRIL
Section 3-6 - Completing the Set Up
V ® 730P / P
OLUSON RO RO
S
ERVICE
Figure 3-23.
2 screws
pull-out Protection
V (BT03)
M
ANUAL