YASKAWA FSDrive-MV1000 Series Instructions For Use Manual page 135

Operation Procedure of Copy Function (Digital Operator)
n
The digital operator will allow the following operations depending on the setting for parameter o3-01, Copy Function
Selection:
INV → OP READ (o3-01 = 1)
Stores the parameter settings of one drive in the digital operator.
Note: The number of the read operations of the digital operator is limited. The maximum number of read operations available is about
100,000 times.
OP → INV WRITE (o3-01 = 2)
Copies parameters from the digital operator to the drive.
OP → INV VERIFY (o3-01 = 3)
Compares the parameters in the drive with the parameter settings saved on the digital operator for matches.
The read procedure is described below:
Note: Set o3-02, Copy Allowed Selection, to 1 (Allowed) when performing read functions. Setting o3-02 to 0 disables the Copy
function and protects the parameters saved in the digital operator.
1 Turn on the power supply.
Press or to display the parameter setting mode screen, and then press
2
.
Select o3-01 (Copy Function Selection) by
3
.
to select an operation. Select "01" (INV → OP Read) in this
Press or
4
example.
5
Press to starts the operation.
After the operation finishes, the screen automatically returns to the copy function
6
selection screen.
7
Press until the screen returns to the initial screen.
YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions
Operating Procedure
,
4.9 Checking and Saving Parameter Default Values
or , and press
LCD Display
Initial setting screen
- MODE - PRG
Programming
HELP DATA
FWD
-PRMSET- PRG
Copy Function Sel
o3-01= 0 *0*
COPY SELECT
← →
FWD
-PRMSET- PRG
Copy Function Sel
o3-01= 1 *0*
INV→OP READ
0
← →
FWD
READ
INV→OP READING
End
READ COMPLETE
Initial setting screen
4
135