Advertisement
M-7019Z Jumper Settings
The M-7019Z can accept current inputs from –20mA to 20mA. No external resistor
required but the corresponding jumper must be shorted. The following figure shows the
jumper positions.
4. Default Settings
Default settings for the M-7017, M-7018 and M-7019 series modules are:
▫ Protocol: Modbus RTU
▫ Module address: 01
▫ Analog input type:
Type 08, -10V to 10V, for the M-7017 and M-7019 series
Type 1B, -150V to 150V, for the M-7017R-A5
Type 0D, -20mA to +20mA for the M-7017C and M-7017RC
Type 05, -2.5V to 2.5V, for the M-7018 series
▫ Baud Rate: 9600 bps
▫ Filter set at 60Hz rejection (Not used by the M-7019R, firmware version B2.6 and
earlier)
M-7019Z 10-channel Thermocouple, Current and Voltage AI Module- QuickStart (Sep/2017)
ICP DAS USA, Inc. |
www.icpdas-usa.com
| 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717
3
Advertisement
