Get The Hardware Required For Your Gpib Instruments; Verify The Operating Environment; Protect Against Electrostatic Discharge (Esd); Allow The Analyzer To Warm Up - Keysight P937 A Series Service Manual

Tests, Adjustments, and Troubleshooting
Before You Begin
Before You Begin
Before checking, verifying, or adjusting the analyzer, refer to the following
paragraphs to:
— get the required Service Test equipment
— make sure the operating environment is within its requirements
— make sure that proper electrostatic discharge (ESD) protection is provided
— make sure the analyzer has warmed up properly to achieve system stability

— review the principles of connector care

Get the Hardware Required for your GPIB Instruments

The hardware required to connect your GPIB instruments to the network
analyzer depends on the type of controller you use.
— Because the P937xA uses a remote controller, you need a GPIB card for the

Verify the Operating Environment

For Operating Environment information, refer to the online Data Sheet at
http://literature.cdn.keysight.com/litweb/5992-2765EN.pdf.

Protect Against Electrostatic Discharge (ESD)

For information on protecting against electrostatic discharge (ESD), refer to the
online Startup Guide at
http://literature.cdn.keysight.com/litweb/pdf/P9370-90001.pdf.

Allow the Analyzer to Warm Up

To achieve the maximum system stability, allow the network analyzer to
warm up for at least 15 minutes.
Review the Principles of Connector Care
For online information on connector care, go to
http://na.support.keysight.com/pna/connectorcare/Connector_Care.htm.
Keysight P937xA PXIe Service Guide
PC.
27